ESTIMATE FORM
Select material and colour
This is the material and colour that you would like for your worktops.
Worktop measurements
All measurements should be in mm and are based on 30mm thick stone. Measure the length and width of each piece and enter the dimensions into the boxes on the right. Please include any peninsula, breakfast bar or island pieces.
Polished Edges
Any visible edges will be polished and shaped according to your specification. Our standard edge finish is a double chamfer or bevel, but other profiles are available on request.
Polished cut-outs
If your sink is an undermount or Belfast or Butler style it will require a polished cut out because the edges will be visible.
Unpolished cut-outs
If your sink is an undermount style or you have a hob which will sit in the stone, you will need an unpolished cut out.
Tap Holes
Required for taps, mixer heads etc.
Drainer Grooves
Drainer Grooves(1 Set = 5 Grooves)
These are available in conjunction with undermount sinks. Normally a set of 5, not only are they a highly decorative feature but also a practical one. Lengths and styles can vary according to taste.
Upstands
An alternative to tiles, upstands run along the walls at the back of your worktops and offer a beautiful, finishing touch to your kitchen. The estimate assumes 100mm high and 20mm thick.
Splashback pieces
Cut and shaped to suit the style of your kitchen, these provide ideal protection from splashes behind your hob or range and sink areas. Normally 20mm thick, enter the height and width of the required pieces in the boxes on the right.
When Ready ?
When it will be ready?
Please ensure your measurements are in mm. 1 m = 1000mm
1st =
mm x
mm
2nd =
mm x
mm
3rd =
mm x
mm
4th =
mm x
mm
Polished Edges
Total Length =
mm
Polished cut-outs :
Unpolished cut-outs :
Tap Holes :
Drainer Grooves :
Upstands :
Total Length =
mm
Please ensure your measurements are in mm. 1 m = 1000mm
1st =
mm x
mm
2nd =
mm x
mm
3rd =
mm x
mm
4th =
mm x
mm
When is it Ready ? :
